Toggle navigation
Categories
Discussions
Activity
🔨Firmware
🧰Starter Kit
💡Wiki
🛒Shop
Sign In
Home
Please note: the forum is closed.
No new user registrations are accepted. For more info, please click here.
Back to Profile
Jozko Remen
About
Username
Jozko Remen
Joined
August 2018
Visits
13
Last Active
January 2022
Roles
🌟 Super Member 🌟
Location
Slovakia
Thanked
7
Posts
21
Activity
Thanked
7
Discussions
7
Comments
14
Might add it. I used K-D500 (dyze design clone) from Trianglelabs and updated to Marlin 2 while was at it. Works fine
Thanked by
1
PetterNilsen
So I created my own version of E3D V6 mount conversion for JGAurora A5. This one is much lighter, more compact than the undocumented, poorly illustrated conversions that are on Thingiverse.<div>…
Thanked by
2
hombre666
Samuel Pinches
Thanks. And all of this started just because I was dumb idiot and when replacing hotend on original X carriage I screwed heatbreak into heatsink that much until I broke it and it was stuck inside. So…
Thanked by
1
Samuel Pinches
As Sam mentions, you need to use custom, not stock Marlin. Just use 2.0 from official repo, configuration files for JGAurora can be downloaded there too (it's a whole pack for all the printers).
<…
Thanked by
1
Samuel Pinches
It depends. For PETG 240 °C, but want to print Carbon Nylon so – 280 - 350 °C. Have completely redesign Xcarriage and mount for E3D V6 as well as BLTouch, once I get all my parts (printed with Ultem …
Thanked by
1
Samuel Pinches
To reply to myself – I have solved it.
Had to change #define BACK_PROBE_BED_POSITION
Thanked by
1
Samuel Pinches